Have custom plant sizing requirements, hard water TDS queries, or need a technician site visit? Speak directly with our deployment engineers.
The Pearl Water 200 LPH semi-automatic RO plant is specified for high-TDS raw water, with inlet TDS up to 3,000 ppm and a rated recovery of 50%. It makes 200 litres of purified water an hour and can run up to 10 hours without a break, which is about 2,000 litres in a full run. At 50% recovery, about 400 litres of raw water an hour goes in and about 200 litres leave as reject. It is built in stainless steel and is semi-automatic, so the operator takes part in some steps. Check a recent water analysis with our engineers before ordering.
What it is
This is a commercial RO plant for sites whose raw water carries more dissolved salts than a standard 1,500 ppm plant is rated for. It is meant for buildings and complexes that need a regular daily volume of purified water.
How it works
Reverse osmosis forces water through membranes at high pressure. The membranes hold back most dissolved salts, which leave as a reject stream, and the purified water, called permeate, goes to use or to storage. As feed water gets saltier, plants are generally run at lower recovery, which is why this model is rated at 50% rather than the 70% of the 1,500 ppm versions.
Key features
Why the problem matters
A plant rated for lower TDS than your water carries can give poor output quality and wear its membranes faster. Matching the rating to your source water is the most important choice in an RO purchase. Your water's hardness and other dissolved content matter too, not only the TDS number.
Where it is used
Commercial buildings, schools, restaurants and large complexes that need a regular supply of purified water from a high-salinity source.
Choose the right product
Start with a water test (TDS and hardness), then compare capacity, automation and recovery.
Sibling prices above are listed excluding GST on the category page. See the full industrial RO range.
A 200 LPH plant specified up to 3,000 ppm, so high-TDS sites aren't pushed into oversized equipment.
You buy a plant specified for your water, not one stretched past its limit.
A fixed hourly rate lets you plan daily volume against your run hours.
The semi-automatic version costs less than the fully automatic 3000 TDS model.
The body is made for continuous commercial use around water and dissolved salts.
A 250 LPH sibling in the same class is available if your demand grows.
Pearl Water has manufactured water treatment plants since 2007, and our engineers check your water analysis.
Everything you need to know about 200 LPH- Semi Automatic RO - TDS
Our product experts are here to help.
"Prompt delivery and professional technician setup managed from the regional hub. Flawless performance."
Action completed successfully.
Action completed successfully.